1 Heat 24 Vac 35-75 Degrees
Frost Sentry Garage Thermostat
This easy-to-operate garage thermostat allows you to maintain temperature to your garage/storage area. Attractive, extra-rugged, highly reliable and accurate, this thermostat will look and perform like new for years to come. Ideal for garages, warehouse, storage facilities, etc.
ICM Controls FS1500L



ICM Controls FS1500L

ICM316

SC060

Intermittent pilot gas ignition control
• Micro-processor-based precision
• Monitors timing, trial for ignition, rollout switch, flame sensing and lockout
• 100% lockout safety feature
• Works with both natural and LP gas systems
• 0.3 amp plus valve load at 24 VAC anticipator setting
• 85 sec trial for ignition
• 0.5 sec flame failure response time
• Remote flame sensing
• Control voltage - line 24 volt (18 - 30 VAC)
• Direct replacement for York 025-27762-700, Johnson Controls G770RJA-1
  

Ultra low cost
• Pin-for-pin compatible with OEM type 621 controls
• Simple time and temperature control
• Must have external relays for fan, reversing valve and auxiliary heat
• High installed base
  
  

  ICM300C

Fully programmable with LCD diagnostic display
• 25-fault memory storage, non-volatile
• Identifies front and back side faults
• Protects against - Voltage unbalance, high/low Voltage, phase loss, phase reversal, faulty power, incorrect sequencing and rapid short cycling
• Mechanical - surface mount using (2) #8 screws mounting, screw terminals
• -20 to 75 deg C LCD operating temperature
• 0 - 10 min adjustable time delay
• Relay, SPDT output

D10829-499

Controls gas valve, inducer draft motor, circulating blower and hot surface igniter
• Microprocessor based precision
• Monitors timing, trial for ignition, flame sensing, lockout, plus pressure, rollout and limit switches
• Twinning compatible with another ICM2805A furnace control
• Diagnostic LEDs to aid in testing/troubleshooting
  

ICM102FB

Intermittent ignition oil primary control with 45 sec safety timing, replacement for Honeywell R8184G Series
• Controls oil burner, oil valve (if desired) and the ignition transformer in response to a call for heat
• Solid state flame sensing circuit
• LED on terminal strip indicates system lockout
• Enclosed safety switch with external reset butTon
• Mounts on standard 4 x 4" junction box (select models may be mounted directly on burner housing)
• C554A cadmium sulfide flame detector and 24 VAC thermostat required
• Replacement for popular competitive models