Henry Technologies 7832 Receiver Shut-Off Valve

7832

Henry Technologies 3-020-053 Plated Steel Sight Glass, 1-1/8-24 Threaded

• Features a Plated Steel Body with Hermetically Sealed Soda Lime Glass Lens

,
,

3-020-053

3-020-053

Henry Technologies 900613-3A Replacement Cap Assembly for Ball Valve

• Can be installed on ball valve or stem extender cap
• Kit includes 6-060-022 cap and 5-023-169 gasket
  ,
  ,
  
  
  
  

  900613-3A

  
  

  900613-3A

Henry Technologies' Magni-Chek Valves are used in discharge lines to prevent flow from the condenser to the compressor during the"off" cycle, or to prevent flow from an operating Compressor to one that is idle. They are also used in liquid lines to prevent reverse flow through the unused expansion device on heat pump systems, or to prevent backup into the low pressure liquid line of a recirculating system during a defrost period. Henry Technologies Magni-Chek Valves are suitable for use with HFC and HCFC refrigerants and their associated oils, as well as other industrial fluids noncorrosive to copper, brass, steel and aluminum.

• Robust design
• Compact
• 2-1/8" OD
• Heat stabilized nylon seat ring for positive shut-off
• Positive back-seating with valve in open position
• Raised seat reduces debris induced sealing issues
• Large diameter diaphragm for greater lift, better flow and longer life
• Hermetic seal between bonnet, diaphragms and body

,
,

F6315

F6315

Henry Technologies S-9104H Brass Reservoir Pressure Valve, 3/8" SAE Female Flare x SAE Male Flare, 500 psi

• Proven design
• Two different pressure settings
• Premium quality teflon seal
• Stainless steel spring
• A reservoir pressure valve is used in a low pressure oil management system
• It is used to vent pressure in the oil reservoir while still maintaining a positive pressure differential between the Oil Reservoir and the compressor crankcase
• This positive pressure ensures an adequate oil supply to the oil level regulators
• The inlet of the valve should be connected directly to the oil reservoir and the outlet should be piped to suction pressure

,
,

S-9104H

S-9104H