|◀ ◀ 1 - 12 of 1132 ▶ ▶|
View:

80% Standard NOX Gas Heating Furnace 33-1/3" H x 17-1/2" W x 29" D

  • 80% AFUE
  • Flame roll--out sensors standard
  • Category I venting
  • Blocked vent switch
  • Louvered door
  • 24 VAC and 115 VAC humidifier terminal
  • Electronic air cleaner termina
  • l
  • N80ESL -- Low NOx units are designed for California installations and meet 40 ng/J NOx emissions. Can be installed in air quality management districts with a 40 ng/J NOx emissions requirement.
  • Cabinet air leakage less than 2.0% at 1.0 in. W.C. and cabinet air leakage less than 1.4% at 0.5 in. W.C. when tested in accordance with ASHRAE standard 193
  • Adjustable heating blower OFF delay
  • Factory set blower ON delay
  • RPJ aluminized steel heat exchanger
  • High temperature limit control prevents overheating
  • Direct ignition with Silicon Nitride ignitor
  • One piece prepainted steel cabinet

    N80ESN0701716A

    • Item#:
    N80ESN0701716A
    Manufacturer Item:
    N80ESN0701716A
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
     
    N80ESN-ICP-Care_Misc
    N80ESN-ICP_Install
    N80ESN0701716A_Spec

    ICP Heat Pump Condensing Performance Series 2.5 Ton

    Quiet performance
  • Single-stage compressor operation
  • Dual fuel capable with a compatible gas furnace and thermostat for energy-saving heating
  • Durably built to withstand bad weather and debris
  • Designed for corrosion resistance and lasting performance
  • Single-speed fan motor
  • System protecting high and low-pressure switches and filter drier
  • Durable, protective inlet grille panels allow easy coil cleaning
  • Baked-on powder coat finish over Gallonvanized steel
  • Compatible with humidity sensing thermostats
  • Suction line accumulator factory installed
  • Bi-flow filter-drier included for field installation
  • Integrated solid state control with time-temperature defrost
  • High and low pressure switches
  • Copper tube/aluminum fin coil
  • Easy access service valves
  • External high and low refrigerant service ports
  • Only two screws to access control panel
  • Post-painted (black) coil fins
  • Coated, weather-resistant cabinet screws
  • Coated inlet grille with 3/8" spacing for extra protection
    • Item#:
    N4H430GKP
    Manufacturer Item:
    N4H430GKP
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
     
    N4H4-ICP-Wiring_Misc
    N4H4-ICP_Broc
    N4H4-ICP_Install

    Up to 92% Multi 18 Speed Gas Heating Furnace 35" H x 21" W x 29-1/2" D

  • Multi 18-speed, constant torque (MCT) ECM blower motor
  • Enhanced diagnostics with easy to read 3 digit display for faults and status
  • Up to 92.1% AFUE in upflow, horizontal and downflow positions
  • Single-stage gas valve
  • Cabinet air leakage less than 2.0% at 1.0 in. w.c. and cabinet air leakage less than 1.4% at 0.5 in. w.c. when tested in accordance with ASHRAE standard 193
  • Approved for manufactured housing/ mobile home applications with accessory (order separately)
  • Select sizes approved for twinning, refer to accessory kit listing
  • All sizes can be installed in air quality management districts with a 40 ng/J NOx emissions requirement

    N92MSN1002120A

    • Item#:
    N92MSN1002120A
    Manufacturer Item:
    N92MSN1002120A
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
     
    N92MSN-Care_Misc
    N92MSN_Install

    ICP Heat Pump Condensing Unit 1-Stage

    Efficiency
  • 13.8 - 17.0 SEER2 / 11.2  14.5 EER2
  • Indoor air quality accessories available
  • Comfort
  • System supports programmable or standard thermostat controls
  • Reliability
  • Non-oz.one depleting, low global warming potential R-454B refrigerant
  • Scroll compressor
  • Internal pressure relief valve
  • Internal thermal overload
  • Filter drier
    Durability
  • Protection Package:
  • Solid, durable sheet metal construction
  • Dense wire coil guard

    N5H5S60AKAAA

    • Item#:
    N5H5S60AKAAA
    Manufacturer Item:
    N5H5S60AKAAA
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
     
    N5H5S-Series-ICP_Spec

    Air Conditioning Condensing Unit 5 Ton 18 SEER 2 Stage 230/1 R454B

    DESIGNED TO FIT YOUR HOME - AND YOUR BUDGET Tempstar has real solutions for your home cooling needs. Our selection of air conditioners have been designed to fit virtually any home and a variety of budgets. From our innovative variable speed Ion Series Air Conditioner Systems with SmartSense Technology...to Performance Series two-stage and single-stage choices, our air conditioners offer summertime comfort you can depend on.
  • Two-stage with high-stage at 100% capacity and low-stage at 75% capacity
  • Sound Level 69 dBA
  • Small Footprint 31" x 31" x 35"
  • Cabinet Design Solid, durable sheet metal construction with baked-on powder paint to protect again dings, dents and weather-based threats. Dense wire grille to protect the coil.
    • Item#:
    N5A8T60CKAWA
    Manufacturer Item:
    N5A8T60CKAWA
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
     
    N5A8T60CKAWA_Spec

    95% Standard NOX Gas Heating Furnace 35" H x 24-1/2" W x 29-1/2" D

  • Up to 96% AFUE in upflow and horizontal positions up to 95% AFUE in downflow position
  • FixedSpeeds, Constant Torque ECM blower motor
  • Supports singlestage cooling units
  • Insulated heat exchanger compartment
  • Approved for Twinning application (0601714 through 1002120) with accessory (order separately)
  • Approved for Manufactured Housing/Mobile Home applications (0401410 through 1202422) with accessory (order separately)
  • Low NOx units are designed for California installations and meet 40 ng/J NOx emissions. Can be installed in air quality management districts with a 40 ng/J NOx emissions requirement.
  • Cabinet air leakage less than 2.0% at 1.0 in. W.C. and cabinet air leakage less than 1.4% at 0.5 in. W.C. when tested in accordance with ASHRAE standard 193

    N95ESN1402422A

    • Item#:
    N95ESN1402422A
    Manufacturer Item:
    N95ESN1402422A
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
     
    N95ESN-Care_Misc
    N95ESN_Install
    N95ESN_Spec

    80% Category I Venting Gas Heating Furnace 33-1/3" H x 21" W x 29" D

  • Multi 18-Speed, Constant Torque (MCT) ECM blower motor
  • Enhanced diagnostics with easy to read 3 digit display for faults and Status
  • 80% AFUE
  • Flame roll-out sensors standard
  • Category I venting
  • Blocked vent switch
  • Louvered door
  • 24 VAC humidifier terminal
  • Electronic air cleaner terminal
  • Select sizes approved for twinning, refer to accessory kit listing
  • N80MSL - Low NOx units are designed for California installations and can be installed in air quality management districts with a 40ng/J NOx emissions limit
  • Cabinet air leakage less than 2.0% at 1.0 in. w.c. and cabinet air leakage less than 1.4% at 0.5 in. w.c. when tested in accordance with ASHRAE standard 193

    International Comfort Products N80MSN0902120A

    • Item#:
    N80MSN0902120A
    Manufacturer Item:
    N80MSN0902120A
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
     
    N80MSN-ICP-Care_Misc
    N80MSN-ICP_Install

    ICP Heat Pump Condensing Unit 5 Ton 18 SEER 2 Stage 230/1 R454B

    Efficiency
  • Up to 18.5 SEER2 / Up to 14 EER2 / Up to 8.5 HSPF2
  • Indoor air quality accessories available Sound
  • Sound level as low as 67 dBA Comfort
  • System supports Thermidistat or standard 2-stage thermostat controls Reliability
  • Non-ozone depleting and low global warming potential R-454B refrigerant
  • Front-seating service valves
  • 2-stage scroll compressor
  • Internal pressure relief valve
  • Internal thermal overload
  • Loss of charge switch
  • Filter drier
  • Balanced refrigeration system for maximum reliability Durability
  • Protection Package: Solid, durable sheet metal construction
  • Post-painted cabinet finish over galvanized steel Applications
  • Long-line - up to 250 feet (76.2 m) total equivalent length, up to 200 feet (60.96 m) condenser above evaporator, or up to 80 ft. (24.38 m) evaporator above condenser (See Long Line Guide for more information.)
  • Low ambient cooling (down to 0°F / -17.8°C ) with approved low ambient accessory kits.
    • Item#:
    N5H8T60AKAAA
    Manufacturer Item:
    N5H8T60AKAAA
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
     
    N5H8T_SPEC

    ICP Heat Pump Condensing Unit 2.5 Ton 14.3 SEER 1 Stage 230/1 R454B

    Efficiency
  • 13.8 - 17.0 SEER2 / 11.2  14.5 EER2
  • Indoor air quality accessories available
  • Comfort
  • System supports programmable or standard thermostat controls
  • Reliability
  • Non-ozone depleting, low global warming potential R-454B refrigerant
  • Scroll compressor
  • Internal pressure relief valve
  • Internal thermal overload
  • Filter drier
    Durability
  • Protection Package:
  • Solid, durable sheet metal construction
  • Dense wire coil guard
    • Item#:
    N5H5S30CKAAA
    Manufacturer Item:
    N5H5S30CKAAA
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
     
    N5H5S-Series-ICP_Spec
    N5H5S_SPEC

    96% Direct Vent 2-Pipe Gas Heating Furnace 35" H x 14-3/16" W x 29-1/2" D

  • Up to 97% AFUE in upflow/horizontal, up to 95% AFUE in downflow
  • Multi 18-speed, constant torque (MCT) ECM blower motor
  • Enhanced diagnostics with easy to read 3 digit display for faults and status
  • Supports single-stage cooling units
  • Insulated heat exchanger compartmen
    t
  • All sizes can be installed in air quality management districts with a 40 ng/J
  • NOx emissions requirement
  • Cabinet air leakage less than 2.0% at 1.0 in. w.c. and cabinet air leakage less than 1.4% at 0.5 in. w.c. when tested in accordance with ASHRAE standard 193
  • Approved for twinning applications (0601716, 0801716, 0802120, 1002120, 1202422, 1402422) with accessory (order separately)
  • Approved for manufactured housing/mobile home applications (0401410 through 1202422) with accessory (order separately)

    International Comfort Products N96MSN0401410A

    • Item#:
    N96MSN0401410A
    Manufacturer Item:
    N96MSN0401410A
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
     
    N96MSN-Care_Misc
    N96MSN_Install

    Air Conditioning Condensing Unit High Efficiency 4 Ton 16 SEER

    REFRIGERATION CIRCUIT
  • Scroll compressors on all models
  • FilterDrier supplied with every unit for field installation
  • Copper tube / aluminum fin coil EASY TO INSTALL AND SERVICE
  • Easy Access service valves on all models
  • External high and low refrigerant service ports
  • Only two screws to access control panel
  • Factory charged with R410A refrigerant BUILT TO LAST
  • Bakedon powder coat finish over galvanized steel
  • Postpainted (black) coil fins
  • Coated, weatherresistant cabinet screws
  • Coated inlet grille with 3/8 (10mm) grille spacing for extra protection (hail guard)

    N4A648GLB

    • Item#:
    N4A648GLB
    Manufacturer Item:
    N4A648GLB
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
     
    N4A6-ICP-Wiring_Misc
    N4A6-ICP_Broc
    N4A6-ICP_Install

    80% Variable Speed Gas Heating Furnace 33-1/3" H x 17-1/2" x 29 D

    Quiet performance
  • Variable 25-speed constant torque blower motor and single-stage gas valve also provide enhanced levels of temperature control and comfort
  • Dual fuel capable with a compatible heat pump and thermostat for energy-saving
  • heating performance
  • Fully insulated cabinet helps keep the heat moving to your ductwork
  • Air purifier and humidifier compatible
  • 10-Year Parts Limited Warranty upon timely registration
  • 20-Year Heat Exchanger Limited Warranty

    N80VSL0901716B

    • Item#:
    N80VSL0901716B
    Manufacturer Item:
    N80VSL0901716B
    Manufacturer:
    INTERNATIONAL COMFORT PRODUCTS
     
    N80VSL-ICP-Care_Misc
    N80VSL-ICP_Install
    |◀ ◀ 1 - 12 of 1132 ▶ ▶|
    View: