Resideo Y8610U Intermittent 1 or 2-Rod Natural Gas/LP Pilot Retrofit Kit for Gas-Fired Atmospheric Furnaces, 24 VAC

Intermittent pilot retrofit kits save energy by converting atmospheric standing pilot systems to intermittent pilot
• Use with natural or LP gas
• Provides 100% pilot gas shutoff if pilot fails to light, after 6 min delay, trial for ignition is repeated
• Ignition trail/delay sequence is repeated until the appliance lights or call for heat is removed
• 2 sec flame failure response time
• 0 or 30 sec pre-purge time
• Ignition sequence - continuous retry, after trial for ignition, pilot gas shuts off for 5 min then another trial for pilot ignition takes place
• Typical gas control - VR8204, VR8304
• Ignition source - internal high voltage spark generator
• Ignition trials to lockout - continuous retry
• 1 amp pilot, 2 amp at 24 VAC maximum valve load
• Q345, Q3451 typical ignition hardware
• 15 or 90 sec lockout timing and ignition trial time
• VR8204, VR8304 typical gas control
  
  

  Honeywell Y8610U4001

Honeywell Home YERM5220R8321/U Programmable Equipment Remote Module with Thermostat, Up to 2 Heat/2 Cool Heat Pump or Conventional, 24 VAC

The Honeywell Home ERM is like a new cordless tool in your toolbox, pull it out whenever it's too costly or time-consuming to run wires from a condensing unit or boiler to control devices
• There are fewer holes to drill and wires to run, just faster, easier installation that gives you more profit per job, make the Honeywell Home ERM your go-to choice for fast, easy equipment installation
• Eliminates the need to run additional wires to your equipment, for example during a heat pump upgrade
• Suitable for outdoor use
• Temperature sensor terminals for outdoor temp sensors or indoor freeze protection
• LED for easy installation checkout
• May reduce damage to homes since wiring/drilling is eliminated
• Attach the ERM to the wall near the compressor or boiler, the location should be at least 3 feet above ground and oriented with the 2-wire exits facing downward mounting
• ERM compressor, boiler connected LEDs
  
  

  Honeywell YERM5220R8321

Thermostat works standalone or with the THM5421R1021 Equipment Interface Module or with the TrueZONE Wireless Adapter.Smart Schedule - programs in seconds for any lifestyle.Patented interview based programming and installer setup.RedLINK wireless communication.Increase profit per job by including RedLINK accessories that provide comfort and convenience. RedLINK accessories include the RedLINK Internet Gateway, Portable Comfort Control (PCC), Wireless Outdoor Sensor, Wireless Indoor Sensor, Wireless Entry/Exit Remote, Wireless Vent and Filter Boost Remote, TrueSTEAM humidifier with Wireless Adapter and TrueZONE zoning panel with Wireless Adapter.

Selectable for residential and light commercial applications. Meets commercial code and is title 24 compliant.

Light commercial - commercial language (occupied and unoccupied), schedule holidays and custom events, remote setback, economizer and time of day. Remote Setback requires the

THM5421R1021 Equipment Interface Module.

Plain language setup, no manual needed.

Alerts and User Interactions Log - Keeps a searchable history of alerts and setting changes to the thermostat to determine if there is a system malfunction or if the issue was caused by a user error. Saves time in troubleshooting and points the technician in the right direction. The Alert and User Interaction Logs are viewable on a computer after you download them from the thermostat to a microSD card.

Customizable Service Reminders allow dealers to remind their customers when its time to call for service, when their warranty is expiring and to provide customized alerts.

MicroSD port for copying the Installer Setup, Customizable Reminders, Custom Events and Holidays to multiple thermostats.

MicroSD port for adding the dealer's contact information on the screen.

1 assignable output on the TH8321 model to control humidification, dehumidification, ventilation or a stage of heating/cooling.

3 assignable outputs on the Equipment Interface Module to control humidification, dehumidification, ventilation or a stage of heating/cooling. The TH8110 and TH8320 models require the use of a Wireless Indoor Sensor to control humidification and dehumidification.

1 assignable input can be used with a wired outdoor, indoor or discharge sensor.

4 assignable inputs on the Equipment Interface Module can be used with wired outdoor, indoor or discharge sensors, occupancy sensor for remote setback and dry contact devices to

trip pre-packaged or custom alerts such as a full drain pan or water leak.

Extend wireless range of the Equipment Interface Module by connecting a THM4000R1000

Wireless Adapter to the ABCD terminals.

Dual powered - battery or hardwired (C wire).

Precise temperature control (+/- 1° F) for reliable and consistent temperature.

Multiple staging options to provide comfort or energy savings.

TH8110R1008, TH8320R1003, and TH8321R1001 are ENERGY STAR Certified

HONEYWELL YTH8321R1002

ZD18X10 Honeywell Square Parallel Blade 24 VAC

Honeywell ZD18X10

ZD16X8TZ Honeywell Home Square Parallel Blade 24 VAC

Honeywell ZD16X8TZ

The ZD is a power close and spring open damper. It has a 24-volt motor used to control circulating air in HVAC systems and used when a normally-open damper is required. The ZD is typically used with the TrueZONE and other electronic zoning systems.

• Mechanical visual position indicator for damper status
• Solid construction using extruded aluminum frame and blades
• Parallel blade design for low leakage performance
• Simple, easy-to wire, two wire installation with a third wire option M4 for LED open only light
• Reliable, strong, 24 volt spring return motor
• Fail-safe, normally open operation
• Ordering instructions: order ZD (dimensions 1) x (dimensions 2), (motor is always mounted on dimensions 2 side) for example, ZD10x8 is a 10 x 8 Inch damper with the motor on the 8 Inch side, but a ZD8x10 is an 8 x 10 Inch damper that has the motor on the 10 Inch side
• Damper can be installed in any orientation (mounting side can be on either the bottom or the side of the duct)
• Motor or actuators mounting - side or top
• 30 sec power closed/10 sec spring return
• 90 deg angular rotation Honeywell Home TrueZone ZD Residential Damper, 10 x 12 Inch, Rectangular, 24 VAC, 0.32 amp, 90 deg Rotation, Import
  
  

  Honeywell ZD10X12TZ

ZD12X8TZ Honeywell Home Square Parallel Blade 24 VAC

Honeywell ZD12X8TZ

ZD20X8TZ Honeywell Home Square Parallel Blade 24 VAC

Honeywell ZD20X8TZ

ZD14X10TZ Honeywell Home Square Parallel Blade 24 VAC

Honeywell ZD14X10TZ