96% Gas Furnace Multi-Position 2-Stage 60K BTU 17" W 3 Ton

Features

Easily applied in upflow, horizontal left or horizontal right, or downflow installation with minimal conversion necessary. Venting kit for downflow (counter-flow) applications on B, C, and D cabinets where side discharge is not possible.

The unit cabinet is compact and easy to install with an ideal height of 33 in.

Full length fold-up duct connector flanges for application flexibility.

Easy access to controls to connect power and control wiring.

No electrical knockouts to deal with, making installation easier.

24 V, 40 VA control transformer and control provisions supplied for single or multi-stage add on cooling.

Built-in, high level self diagnostics with fault code displays standard on integrated control module for reliable operation.

Front-facing screws on flame sensor and hot surgace ignitor for ease of service.

Front-facing screws on blower assembly for easy access and removal of blower.

Constant torque blower motor for cooling SEER2 enhancement.

Blower-off delay for cooling SEER2 improvement.

Continuous fan options for indoor air quality (IAQ) performance.

Airflow leakage less than 2% of nominal airflow for duct performance testing conditions.

Low unit current requirement for easy replacement application.

Electronic hot surface ignition saves fuel cost with increased dependability and reliability.

100% shut-off main gas valve for extra safety.

Inducer rotates for easy conversion of venting options.

The 26k model is not convertible for use with propane (LP) gas. All other models are fieldconvertible for use with propane (LP) gas with an optional propane accessory conversion kit.

Five-speed direct drive standard ECM blower motor.

Hi-tech tubular aluminized steel primary heat exchanger.

Corrosion resistant stainless steel secondary heat exchanger including rear cover pan and front vestibule panel.

Quiet inducer operation.

Timed on, adjustable off blower capability for maximum comfort.

Blower door safety switch below the blower deck.

Solid removable bottom panel allows easy conversion for bottom return air applications.

Twinning terminal for controlling two identical models installed with a common duct system. No external kit is required.

External air filters are used for maximum flexibility in meeting customers' IAQ needs.

1/4 turn knobs are provided for easy independent door removal.

Insulated blower compartment for thermal and acoustic performance.

Internal condensate trap design (patent pending) provides condensate management options and is self priming to prevent nuisance problems.

Protection included from air intake, exhaust vent, or condensate blockage. Venting applications may be installed as either two-pipe sealed combustion or single-pipe vent (except 26k) using indoor combustion air.

No special vent termination required.

These condensing furnace models produce <40 ng/J NOx emissions.

Fold-up duct connector flanges for application flexibility.

Patented self-priming internal condensate trap design for easy installation.

York RG19060A10MPS1

Item#:

RG19060B12MPS1

Manufacturer Item: