Home  > VMC GROUP(x)
|◀ ◀ 1 - 12 of 36 ▶ ▶|
View:

Oil Burner Nozzle .65 GPH x 70 Degree AS 100% Corrosion Resistance Stainless Steel

Flow Rate
  • Atomizing nozzles are available in a wide range of flow rates, all but eliminating the need for specially calibrated nozzles. Between 1.00 GPH and 2.00 GPH, for example, seven different flow rates are available. Generally, with hot water and warm air heat, the smallest firing rate that will adequately heat the house on the coldest day is the proper size to use and the most economical. Short on-cycles result in low efficiency. Another guideline is to select the flow rate that provides a reasonable stack temperature regardless of the connected load. (According to the New England Fuel Institute, aim for a stack temperature of 400°F or lower on matched packaged units or 500°F or lower on conversion burners.) If the boiler or furnace is undersized for the load, it may be necessary to fire for the load and ignore the efficiency
    Spray Angle
  • Spray angles are available from 30° through 90° in most nozzle sizes to meet the requirements of a wide variety of burner air patterns and combustion chambers. Usually it is desirable to fit the spray angle to the air pattern of the burner. In todays flame retention burner, it is possible to fire more than one spray angle with good results. Generally, round or square combustion chambers should be fired with 70° to 90° nozzles. Long, narrow chambers usually require 30° to 60° spray angles.
  • Burner Air Patterns
  • Burner air patterns are much like nozzle spray patterns in that they fall into the same general classifications, either hollow or solid. As you would expect, a burner with a hollow air pattern generally requires a hollow cone fuel nozzle. A burner with a solid air pattern will give highest efficiency with a solid cone nozzle, but the flame will probably be longer

    Danfoss .65-70AS

    • Item#:
    .65-70AS
    Manufacturer Item:
    030F7514
    Manufacturer:
    DANFOSS LLC(HVAC/R)
     
    DANFOSSNOZZLE

    Item#:
    DAN067L5957

    Item#:
    DAN067L5859

    Item#:
    DAN067L5858

    Item#:
    DAN067L5857

    Item#:
    DAN067L5856

    Scroll A/C Compressor 10 Ton 120K BTU 208/230/3 POE R407C 7/8" Discharge

    Danfoss HCP120T2LC6 Scroll A/C Compressor
    • 10 Ton 120K BTU 460 VAC 3 PH POE R410A
    • Internal inherent protection
    • Compressor family series
    • Model variation
    • Quiet reliable operation, optimized scroll and seal design
    • High efficiency motor
    • Improved temperature protection
    • Larger shaft bearing system
    • Internal pressure protection
    • New shutdown solution
    • Redesigned shell
    • Molded plug connectio,

      Danfoss HCP120T2LC6

    Item#:
    HCP120T2LC6
    Manufacturer Item:
    120U0766
    Manufacturer:
    DANFOSS LLC(HVAC/R)
     
    DANFOSSSCROLLPARTS_SPEC

    Scroll A/C Compressor 4-1/4 Ton 51K BTU 208/230/1 POE

    Danfoss HRH051U4LP6 Scroll A/C Compressor
    • 4-1/4 Ton 51K BTU 230 VAC 1 PH POE
    • Internal inherent protection
    • Compressor family series
    • Model variation
    • Quiet reliable operation, optimized scroll and seal design
    • High efficiency motor
    • Improved temperature protection
    • Larger shaft bearing system
    • Internal pressure protection
    • New shutdown solution
    • Redesigned shell
    • Molded plug connectio,
      ,

      Danfoss HRH051U4LP6

    Item#:
    HRH051U4LP6
    Manufacturer Item:
    120U3333
    Manufacturer:
    DANFOSS LLC(HVAC/R)
     
    DANFOSSSCROLLPARTS_SPEC

    Scroll A/C Compressor 4 Ton 47K BTU 230/1 R22/R407C 3/4" X 1/2" OD W/Plug

    Danfoss HRM047U1LP6A

    Danfoss HRM047U1LP6A

    Item#:
    HRM047U1LP6A
    Manufacturer Item:
    120U3311
    Manufacturer:
    DANFOSS LLC(HVAC/R)
     
    DANFOSSSCROLLPARTS_SPEC

    Scroll A/C Compressor 2-1/2 Ton 32K BTU 208/230/1,R410, POE W/Plug

    Danfoss HRH032U1LP6 Scroll A/C Compressor
    • 2-1/2 Ton 32K BTU 230 VAC 1 PH POE
    • Internal inherent protection
    • Compressor family series
    • Model variation
    • Quiet reliable operation, optimized scroll and seal design
    • High efficiency motor
    • Improved temperature protection
    • Larger shaft bearing system
    • Internal pressure protection
    • New shutdown solution
    • Redesigned shell
    • Molded plug connectio

      Danfoss HRH032U1LP6

    Item#:
    HRH032U1LP6
    Manufacturer Item:
    120U3321
    Manufacturer:
    DANFOSS LLC(HVAC/R)
     
    DANFOSSSCROLLPARTS_SPEC

    Scroll A/C Compressor 5 Ton 63K BTU 208/230/1 POE

    Danfoss HRH036U1LP6 Scroll A/C Compressor
    • 5 Ton 63K BTU 230 VAC 1 PH POE
    • Internal inherent protection
    • Compressor family series
    • Model variation
    • Quiet reliable operation, optimized scroll and seal design
    • High efficiency motor
    • Improved temperature protection
    • Larger shaft bearing system
    • Internal pressure protection
    • New shutdown solution
    • Redesigned shell
    • Molded plug connectio,
      ,

      Danfoss HRH036U1LP6

    Item#:
    HRH036U1LP6
    Manufacturer Item:
    120U3322
    Manufacturer:
    DANFOSS LLC(HVAC/R)
     
    DANFOSSSCROLLPARTS_SPEC

    Item#:
    HRH044U4LP6
     
    DANFOSSSCROLLPARTS_SPEC
    |◀ ◀ 1 - 12 of 36 ▶ ▶|
    View: